Tel : 0086-532-55576871

E-mail:Ornate@ornatetire.com

© 2018 Ornate Tire Co., Ltd 鲁ICP备10018947号 Powered by www.300.cn

>
Factory Show

Factory Show




Ornate Tire founded in 1999 ,more than 15 years history
 
1,000,000 square meters
Ornate is a enterprise specialized in tyre research and development &manufacture.
Now the factory annual production capacity of 6.000.000 piece PCR tires,1.200.000 sets TBR tires and 10.000 sets OTR tyres
 
Our Technical Staff & International Cooperation
 
With the domestic well-known institutions of cooperation projects
Hiring international technical staff and management team from international tire manufacturers
 
Our Production Facilities
 
Calender: Rodolfo (Italy)&VMI (Nertherland)
Extruding:Krupp (Germany)
Put the rubber film into the Extruding,thus get different semi-finished rubber components: the tread,the side wall and triangle strip.
 
MOLDING WHEEL RIM
 
Wheel rim is twined by many steel wire,which be put on rubber material.
 
CUTTING FLAPS
 
In this section, the cord fbric will be cut into the applicable width and connected joint.
The width and the angel change of the cord fbric, mainly depends on the tire structure design requirements.
 
ROLLING
 
Raw materials cord thread through the rolling machine and both sides of cord thread can be put on a thin rubber material, and the finished product called "cord fbric".
 
Building:VMI(Netherland)
 
Tyre Forming process is assemb all the semi-finished products into tyre embryo in the molding machine.The tyre embryo is not be curing,then it’ll be sent to Vulcanization process after test.
 
VULCANIZATION PROCESS
 
The tyre embryo is put on vulcanizer, in the mould with appropriate time and conditions, then get finished products tires,this process will take about 20-30 mins. Then the tires have the finish product’s appearance, such as pattern,design and tread.
 
 
PCR TIRE WAREHOUSE
 
 
 
TBR TYRE WAREHOUSE